Acid-resistant enclosure CHB 500x500x300mm

Total height with a cap 643mm.

Accessories:
Wall holders, rain canopy, interior doors, document pocket, locks, keys.
Construction:
AISI 316L ≠ 1.2mm acid resistant steel.
Monolithic body, bent and welded in a continuous system with an integral 30 ° roof.
M6 full sleeves on the body enable mounting to the wall without any mechanical treatments.
Door:
AISI 316L ≠ 1.2mm acid resistant steel.
AISI 304 stainless steel retractable hinges with an opening angle of more than 120 °.
Locks made of stainless steel with one key cut, a double lever 3mm (various cuts on request).
Polyurethane gasket poured around the perimeter, temperature range -40 ° C ÷ + 90 ° C.
Equipment:
Galvanized mounting plate, single point lock, 3mm double bar key.
Materials:
Stainless steel: AISI 316L (EN 1.4404).
Finish: Scotch-Brite.
Mounting plate: galvanized sheet ≠ 2.5mm.
Certificates:
EN62208, EN60529, EN62262
UL508A - CSA C22.2 n °. 14-13
NEMA Type 1,12,4,4X

Construction details of the acid-resistant enclosure with CHB roof:


Rear fasteners enable the correct mounting of the CHB acid-proof box on the wall (or directly on the devices) without additional mechanical treatments that could lower the high degree of protection IP66.

Hinges made of micro acid-resistant steel castings with an opening angle of more than 120 °.

Polyurethane gasket. Operating temperature range: -40 ° C to + 90 ° C.

Edges for safety. All edges are rounded to prevent accidental injury while handling the enclosure.

Possible modifications of AISI 316L acid-proof enclosures according to the customer's design at the production stage.

Please contact us by e-mail at the following address:inoxbox@inoxbox.pl

On the top right or below (depending on the device) there are accessories dedicated to CHB AISI 316L acid-proof enclosures.