CCA stainless steel enclosure 800x600x300mm

Equipment:
Galvanized mounting plate, 2 single-point locks, 3mm double-bar key.
Accessories:
Wall holders, rain canopy, document pocket, locks, keys, cable management collar, interior doors.
Construction:
Stainless steel ≠ 1.2mm.
A monolithic body, bent and welded in a continuous system. M6 full sleeves on the body enable mounting to the wall without any mechanical treatments.
Door:
Stainless steel ≠ 1.2mm.
Retractable AISI 304 stainless steel hinges with an opening angle of more than 120 °.
Chrome plated steel locks with one key cut, 3mm double lever (on request, AISI 304 and various cutouts).
Polyurethane gasket poured around the perimeter, temperature range -40 ° C ÷ + 90 ° C.
Materials:
Stainless steel: AISI 304 (EN 1.4301). Made of AISI 316 (EN 1.4404) on request.
Finish: Scotch-Brite.
Mounting plate: galvanized sheet ≠ 2.5mm.
Certificates:
EN62208, EN60529, EN62262
UL508A - CSA C22.2 n °. 14-13
NEMA Type 1,12,4,4X

Design details of the CCA stainless steel enclosure:

The rear mounts allow the box to be properly attached to the wall (or directly
on devices) without performing additional mechanical treatments that could lower the high degree of protection IP66.

Micro stainless steel hinges with an opening angle of more than 120 °.

Polyurethane gasket. Operating temperature range: -40 ° C to + 90 ° C.

Rounded edges for safety. All edges are rounded to prevent accidental injury while handling the enclosure.

Possible modifications of stainless steel casings for the customer's design at the production stage.

Please contact us by e-mail at the following address:inoxbox@inoxbox.pl

On the top right or below (depending on the device) there are accessories dedicated to stainless steel enclosuresAISI 304 seriesCCA.